Thursday, July 19, 2001


 

 

 

 

 


Wyse Terminal Setups

IBID TERMINAL SETUP SHEET


WYSE 50

  • hold down SHIFT-SETUP to enter setup mode.
  • hit ESC for default values
  • highlight and hit spacebar to set Handshake = DTR
  • arrow down, and arrow right three times to Modem Baud Rate
  • highlight and hit spacebar to set baud= either 38400 or 19200
  • hit CAPS LOCK
  • again, hold down SHIFT-SETUP; hit Y for yes

  • WYSE 55

  • hold down SHIFT SETUP
  • hit ENTER for default values
  • select F2-GENERAL
  • highlight with arrow keys and hit spacebar so that
    • PERSONALITY = WYSE50+
    • ENHANCE =OFF
  • select F4-COMM
  • highlight with arrow keys and hit spacebar so that
    • MDM RC HSK= DTR
    • AUX RC HSK = DSR
  • select F5-PORTS
  • highlight with arrow keys and hit spacebar so that
    • MDM BAUD= either 38400 or 19200
  • select F12-Exit
  • hit CAPS LOCK, then use spacebar to change SAVE? to Yes
  • hit F12 to exit and save.

  • WYSE 60

  • hold down SHIFT-SETUP
  • arrow to DEFAULT ALL then hit SHIFT-SETUP again for defaults
  • select F2-GENERAL
  • highlight with arrow keys and hit spacebar so that
    • PERSONALITY = WYSE50+
    • ENHANCE = OFF
  • select F4-COMM
  • highlight with arrow keys and hit spacebar so that
    • BAUD RATE 38400 or 19200 and
    • RCV HANDSHAKE= DTR
    • AUX=DSR
  • hit F10-Exit
  • press CAPS LOCK, then arrow to highlight SAVE ALL.
  • hit F10-Exit

  • TO "REBOOT" any of the Wyse terminals, with the terminal off, hold down the "G" key and turn on the terminal.

     

    | home | about us | products | sales | support |